Logitech Carbon Fiber Paddle Set

1. Turn the wheel over and remove the small rear screws.

2. Remove the six black front screws.

3. Carefully remove the wheel and disconnect the circuit board connector.

4. Remove the three long screws to detach the button assembly from the motor base.

5. Remove the four screws, two on each side, securing the original paddles to the black assembly.

6. Remove the original paddles.

7. Position the magnetic paddle mod on the assembly. Leave it loose until the new paddles are installed and adjusted.

8. Insert the new paddles and check that the magnets align. If they do not attract correctly, swap the left and right paddles; they are symmetrical and interchangeable.

9. Use the supplied screws to secure the new paddles through the original mounting holes.

10. Fit and tighten the four supplied nuts on the inside to secure the paddles.

11. Refit the button assembly to the motor base using the three original long screws.

12. Reconnect the circuit board to the motor base.

13. Reinstall the six black front screws. Do not overtighten the lower screws, as this can interfere with the lower buttons.