Install your Logitech Wheel Mod

Remove the six black screws from the front of the original Logitech wheel.

Turn the wheel over and remove all the small screws from the back.

Remove the two screws securing the L2 and R2 buttons, then remove those buttons.

Carefully separate the original wheel from the base. Disconnect the internal connector linking the circuit board to the motor base, then fully remove the wheel.

Remove the silver screws securing the green circuit board.

Remove the two larger screws underneath the original metal wheel plate, then remove the plate.

Remove the L3 and R3 buttons.

Reinstall the green circuit board on the base using the original silver screws.

Reconnect the circuit board to the base using the original connector.

Close the base and turn it over.

Reinstall all the small black screws on the back.

Install the spacers on the base. Follow the model-specific note below for the lower rectangular spacer.

Install the buttons in the BRG Wheel Mod.

Longer buttons: upper positions (L2 / R2). Shorter buttons: lower positions (L3 / R3).

Position the BRG Wheel Mod on the base.

Secure the wheel using the six original screws removed in step 1.